Routine and advanced acoustic wireline logs.
2015 Monitoring Seismic Survey at Bell Creek The raster layers represent a map of the RMS amplitude slice between the horizons Springen Ranch and the Skull Creek (Muddy Formation) enclosing the Bell Creek sand reservoir at the Bell Creek oil field. This gridded dataset was interpolated within ArcGIS based upon seismic amplitude values measured across the study area. Additional information regarding this data and interpretations can be found in the following document: Salako, O., Livers., A.J., Burnison, S.A., Hamling, J.A., Wildgust, N., Gorecki, C.D., Glazewski, K.A., and Heebink, L.V., 2017, Analysis of Expanded Seismic Campaign: Plains CO2 Reduction (PCOR) Partnership Phase III draft Task 9 Deliverable D104 for U.S. Department of Energy National Energy Technology Laboratory Cooperative Agreement No. DE-FC26-05NT42592, Grand Forks, North Dakota, Energy & Environmental Research Center, June. Monitor2015 contains 4 rasters: Clp2015ovr12 is the 2015 monitor survey clipped down to where it overlaps the 2012 baseline survey. Clp2015ovr14 is the 2015 monitor survey clipped down to where it overlaps the 2014 monitor survey. Clpdiff1512 is the RMS amplitude difference between the monitor 2015 and baseline 2012 survey. Clpdiff1514 is the RMS amplitude difference between the monitor 2015 and monitor 2014 survey.
Mixed open hole logs. Data sets are PDS, LAS, and LPT files that commonly contain multiple logs. Types of logs include mineralogy, fluid saturation, resistivity, gamma ray, density porosity, neutron porosity, photoelectric sonic, PEX, ECS, laterolog, CDL, VDL, bond log, CBL, CCL, MAP image waveform, DSI, FMI, CMR, and PE.
Input data and heave results (unsteady RANS-VOF overset simulations performed in Star-CCM+) for a float with an ellipsoid geometry. Five extreme sea states were considered, as detailed in the conference paper "Application of the Most Likely Extreme Response Method for Wave Energy Converters" by Quon et al. (see resource below). These sea states were extrapolated from conditions near Humboldt Bay, California. Focused waves were generated using the MLER module of the Wave Design Response Toolbox (WDRT) and specified at the inlet boundary conditions. The device was constrained to heave only and a PTO was not modeled.